Tuesday, July 9, 2013

The Bridge at Long Lake

Hey friends and happy Tuesday! We are one day closer to the weekend!

It has been a while since I wrote about any progress at our cabin, so today I wanted to write a bit about what has been going on at Long Lake.

We have chosen the location on the property where we are going to build the cabin, and have cleared some of the land on the property. Since it is really busy on the home front right now with several projects on the go, items needing our attention we decided to wait until fall to get started on the building process with our fingers crossed that we will be roof tight by winter.

The land, where we will be building our cabin is across a brook, so our only access to the property is by boat, helicopter, rubber boots and balance or a bridge. Since we don't have any helicopters at our disposal and I have zero balance on a good day, we decided we would have to build a bridge. Nothing fancy - just a basic, walking bridge that allows us to get across the brook without a soaker and haul building materials across.


We started the bridge building process by using two telephone poles that were on the property brought out by another member of the family originally for use in another project. They fit the bill perfectly.




We used boulders that were in the brook and added a few cinder blocks as supports for the far end of the poles.


Once we had the poles as level as we could get them, we measured and cut lumber to length for the walking surface of the bridge. Using a chalk line, we kept the wood as straight as possible and spaced them approximately two inches apart.




Since the span for the bridge was over 80' the telephone poles were able to reach less than halfway. We then had to cut and fall two large trees to complete the rest of the bridge.

 






Because the trees were so heavy, there was no way we could lift them, so we wenched them into place using our Yamaha Rhino and a pulley system.



After the trees were limbed and wenched into place, the fellas leveled everything with blocks and wood.

 



It was a very tiring job wenching and prying while standing and balancing on boulders and rough terrain. Because everything was planned in advance, and the proper equipment was being used, the whole process went quite smoothly.


MacGyver is exhausted from all the bridge building but clearly gives the bridge his seal of approval.


We built the bridge in such a way to not impede the flow of the brook, using rock, cinder block and raw wood for materials. If the bridge has to be removed in the future for whatever reason, we will be able to do so without any damage to the land.
 



 

No comments:

Post a Comment